<%NUMBERING1%>.<%NUMBERING2%>.<%NUMBERING3%> PRTG Manual: SNMP Dell PowerEdge Physical Disk Sensor

Dell OpenManage Server Administrator or iDRAC 7

This sensor requires the Dell OpenManage Server Administrator (OMSA) tool to be installed on the target system. Make sure that you enable SNMP in the OMSA.

For more information, see the Knowledge Base: What do I need to monitor Dell servers?

You can also monitor Dell PowerEdge servers with this sensor via iDRAC 7.

Sensor Name

Enter a name to identify the sensor. By default, PRTG shows this name in the device tree, as well as in alarms, logs, notifications, reports, maps, libraries, and tickets.

If the name contains angle brackets (<>), PRTG replaces them with braces ({}) for security reasons. For more information, see the Knowledge Base: What security features does PRTG include?

Parent Tags

The tags that the sensor inherits from its parent device, parent group, and parent probe.

This setting is for your information only. You cannot change it.

Tags

Enter one or more tags. Confirm each tag with the Spacebar key, a comma, or the Enter key. You can use tags to group objects and use tag-filtered views later on. Tags are not case-sensitive. Tags are automatically inherited.

It is not possible to enter tags with a leading plus (+) or minus (-) sign, nor tags with parentheses (()) or angle brackets (<>).

For performance reasons, it can take some minutes until you can filter for new tags that you added.

The sensor has the following default tags that are automatically predefined in the sensor's settings when you add the sensor:

• dell
• physicaldisk
• snmpdell
• snmpdellphysicaldisksensor

Priority

Select a priority for the sensor. This setting determines the position of the sensor in lists. The highest priority is at the top of a list. Choose from the lowest priority () to the highest priority ().

Disk

The physical disk that this sensor monitors.

Data Source

The interface that PRTG uses to get monitoring data. This is either Dell OMSA or iDRAC.

Primary Channel

Select a channel from the list to define it as the primary channel. In the device tree, the last value of the primary channel is always displayed below the sensor's name. The available options depend on what channels are available for this sensor.

You can set a different primary channel later by clicking below a channel gauge on the sensor's Overview tab.

Graph Type

Define how different channels are shown for this sensor:

• Show channels independently (default): Show a graph for each channel.
• Stack channels on top of each other: Stack channels on top of each other to create a multi-channel graph. This generates a graph that visualizes the different components of your total traffic.
  You cannot use this option in combination with manual Vertical Axis Scaling (available in the channel settings).

Stack Unit

This setting is only visible if you select Stack channels on top of each other above.

Select a unit from the list. All channels with this unit are stacked on top of each other. By default, you cannot exclude single channels from stacking if they use the selected unit. However, there is an advanced procedure to do so.

Component Status

The component status

• Up state: OK
• Warning state: Non Critical
• Down state: Critical, Non Recoverable, Other, Unknown

Disk State

The disk status

• Up status: Non-Raid, Online, Ready
• Warning status: Foreign
• Down status: Blocked, Critical, Failed, Non Recoverable, Other, Removed, Unknown

This channel is the primary channel by default.

Downtime

In the channel table on the Overview tab, this channel never shows any values. PRTG uses this channel in graphs and reports to show the amount of time in which the sensor was in the Down state

Roll Up Status

The roll up status

• Up state: OK
• Warning state: Non Critical
• Down state: Critical, Non Recoverable, Other, Unknown

This channel requires that Dell OMSA is installed on the target system.

S.M.A.R.T. Warning

The S.M.A.R.T. warning status

• Up status: No
• Down status: Yes